Engineering, 08.05.2021 01:00 vsuescun10

A coil spring in an oscillating machine runs at between 500 and 1500 rpm (cycles per minute). The spring diameter is 50 mm and the wire diameter is 4 mm. The free length of the spring is 200 mm and the solid length is 80 mm. The ends are squared and held between flat, parallel plates. The spring is made of hard-drawn steel wire. Based on comparing the critical frequency and the range of operating frequencies, is this a good design? Given: For the specific weight of steel, use 77,000 N/m
a. Calculate the number of active coils, Na.
b. Calculate the approximate spring rate, k.
c. Calculate the weight of the spring, W.
d. Calculate the lowest critical frequency, f in cycles per second.
e. Is this an acceptable design?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.

Answers: 1

Answer

You know the right answer?

A coil spring in an oscillating machine runs at between 500 and 1500 rpm (cycles per minute). The sp...

Questions