Engineering, 08.05.2021 04:10 20jacksone
An engineer follows the rigorous design procedure for end plate connections according to the ASD method. So far it has been determined that the thickness of the end plate is 0.5 in. while its ultimate tensile strength is 100 kips. Four holes which are 0.875 in. in diameter are to be drilled into the plate to accommodate bolts. From these values, what is the factored bearing deformation strength per bolt
Answers: 3
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
An engineer follows the rigorous design procedure for end plate connections according to the ASD met...
Mathematics, 22.10.2020 18:01
Spanish, 22.10.2020 18:01
Biology, 22.10.2020 18:01
Mathematics, 22.10.2020 18:01
World Languages, 22.10.2020 18:01
Mathematics, 22.10.2020 18:01
Mathematics, 22.10.2020 18:01
Mathematics, 22.10.2020 18:01
Mathematics, 22.10.2020 18:01
History, 22.10.2020 18:01
Mathematics, 22.10.2020 18:01
Mathematics, 22.10.2020 18:01
Mathematics, 22.10.2020 18:01
Health, 22.10.2020 18:01