Engineering, 10.05.2021 18:30 mroueh21
Project: Researching Materials, Time, and Cost for Product Modifications
Assignment Directions
When a client approaches an engineer about a project, the engineer might not have all of the information available to create a bid proposal. The engineer might need to research time, cost, and materials needed to complete the project. Take a moment to think of an everyday object. It could be a stapler, a fork, or even a shoe. You must choose two of the three analyses (time, cost, or materials) to research for your chosen object. Once you have completed the research, you will present the documentation and explain your findings in a script for a 3- to 5-minute oral presentation. Remember that a bid proposal is intended to persuade a client to use your services, so be sure to use persuasive techniques to convince your audience to choose your bid proposal.
Assignment Guidelines
Each script for a 3- to 5-minute presentation must include two of the following:
cost analysis
materials analysis
time analysis
Each analysis must include graphic representation.
Submission Requirements
One to two pages double spaced
Proper grammar and vocabulary
Question # 1
File Upload
Upload your presentation that demonstrates your analyses from your research on time, cost, and/or materials for your object (choose two).
Answers: 1
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
Engineering, 04.07.2019 19:10
Which of the following is the most important advantage of a large field of view? a. allows larger areas to be examined b. relieves eyestrain c. minimizes parallax errors. d. increases precision in proportion to the in- crease in field of view
Answers: 2
Engineering, 04.07.2019 19:10
Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)
Answers: 3
Engineering, 06.07.2019 02:30
Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers
Answers: 3
Project: Researching Materials, Time, and Cost for Product Modifications
Assignment Directions
Mathematics, 22.05.2020 04:03
Mathematics, 22.05.2020 04:03
Mathematics, 22.05.2020 04:03
History, 22.05.2020 04:03
English, 22.05.2020 04:03
Mathematics, 22.05.2020 04:03
History, 22.05.2020 04:03
Spanish, 22.05.2020 04:03
French, 22.05.2020 04:03
English, 22.05.2020 04:03
Mathematics, 22.05.2020 04:03