Consider circuit below utilizing MOSFETs with VT = 2 V, (W/L)*kn’ = 1 mA/V2 , λ = 0.01 V-1 , CGS = 1 pF and CGD = 0.2 pF. VDD = VSS = 5 V, I0 = 0.5 mA, RS = RD = RL = 10 kΩ, CS = 1 µF, C2 is infinite, i. e. can be replaced with short circuit for all frequencies of interest. 1. Find the mid-band voltage gain; 2. Estimate the low and high 3dB cutoff frequencies fL and fH; 3. Sketch the magnitude frequency response Bode plot and mark it with the values found. 4. Replace RL with CL = 1 nF and repeat 1, 2 and 3.

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?