Engineering, 12.05.2021 01:00 joanna3895

A straight and non-moving linear vortex of the initial circulation |-0, is submerged into a viscous fluid of viscosity mu and density p, thus kinematic viscosity of v (think about a straight tornado just formed in air). Due to the viscous effects, the vorticity surrounding this vortex evolves in time as a function of the above-mentioned parameters, the radial distance from the vortex center r and time t. 1. Using the concepts of dimensional analysis, find a dimensionless form of this function f.

2. Using the concept of self-similarity, find the self-similar form of this function f.

3. Explain why it is beneficial for an experimentalist to establish this form of self-similar function without solving Navier-Stokes equations or experimental measurements.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)

Answers: 3

Answer

Engineering, 04.07.2019 19:20

To save energy, the air supply to a 2000 ft office has been shut off overnight and the room temperature has dropped to 40°f. in the morning, the thermostat is reset to 70°f and warm air at 120 f begins to flov in at 200ft'/min. the air is well mixed within the room, and an equal mass flow of air at room temperature (changing with time) is withdrawn through a return duct. the air pressure is nearly 1 atm everywhere. ignoring heat transfer with the surroundings and kinetic and potential energy effects, estimate how long it takes for the room temperature to reach 70°f. plot the room temperature as a function of time.

Answers: 1

Answer

Engineering, 06.07.2019 02:30

1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction

Answers: 1

Answer

You know the right answer?

A straight and non-moving linear vortex of the initial circulation |-0, is submerged into a viscous...

Questions