Engineering, 12.05.2021 04:00 iisofieii1978

Answer TRUE or FALSE regarding the optimum design criteria of 7TZP thermal barrier coatings for jet engine turbine blades? The yttria content of the top coat layer (columnar grains) should be maximized and should exceed at least 15 wt% in the ceramic.
The yttria content of the bonding layer should be maximized and should exceed at least x = 1.0 within a bonding layer of Ni-16-Cr-5Al-xY.
The coefficients of thermal expansion for the TBC sublayers should be matched as close as possible to prevent thermal stresses that could promote cracking and spalling of the TBC. [Select] The thermal conductivities of the TBC sublayers should be matched as close as possible to the underlying base metal (usually a Ni-based superalloy).
Air gaps between grains of top coat 7TZP should be minimized, since they act as stress concentrators for each of the as-grown grains.
Soda-lime glass is the preferred composition for the bonding layer of modern columnar TBCs.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

Answer

You know the right answer?

Answer TRUE or FALSE regarding the optimum design criteria of 7TZP thermal barrier coatings for jet...

Questions