Engineering, 13.05.2021 19:30 mustafaserang582

g You are responsible for design and construction of a new freeway. Estimated flow rate for the freeway is each direction in design hour is 7500 vph. The deigned freeway should meet the following conditions: a) It should operate at level of service of B or higher during the design hour and A for the rest of the times. b) The base free flow speed for the freeway is 75 mph and free flow speed should not fall below 70 mph. c) Due to topography constraints, the widths of the cross section cannot exceed 200 ft. d) On average, number of access points to the freeway 2 per mile. What is your recommended design for this section of the freeway

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Wiy doeres rere okhn a pump whon working betwon the same pressure range?

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Abarometer contains mercury with a density of 13600 kg/m3. atmospheric conditions are 95.8 kpa and 20 °c at 20 °c, the vapor pressure of the mercury is 0.000173 kpa. the column of mercury will rise to a height of most nearly. select one: a)- 0.38 m b)- 0.82 m c)- 0.48 m d)- 0.72 m

Answers: 1

Answer

You know the right answer?

g You are responsible for design and construction of a new freeway. Estimated flow rate for the free...

Questions