Engineering, 18.05.2021 15:50 makiahlynn3642
Stereolithography is to be used to build the part in Figure below. Dimensions of the part are shown in detail. The laser beam diameter = 0.175mm, and the beam can be moved across the surface of the photopolymer at = 600mm/s. Layer thickness = 0.15mm. Compute an estimate of the time required to build the part, if 8s are lost each layer to lower the height of the platform that holds the part. Neglect post-curing time.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
Engineering, 04.07.2019 18:10
Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.
Answers: 2
Engineering, 04.07.2019 18:10
The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false
Answers: 1
You know the right answer?
Stereolithography is to be used to build the part in Figure below. Dimensions of the part are shown...
Questions
Physics, 26.03.2020 23:50
Computers and Technology, 26.03.2020 23:50
Mathematics, 26.03.2020 23:50
Geography, 26.03.2020 23:50
