Engineering, 19.05.2021 18:50 tammydbrooks43

A new development is being proposed over a 10 acres site. The developer wants to divide the site into 40 lots and have a single-family home at each lot. Each home will take about 40 percent of the lot size. 30% of the lot will be landscaped with shrubs, the rest of the lot will be lawns and sidewalks. After finishing developing the site, the first rainfall of the season hits the development. The rainfall lasted for 3 hours with an average of 0.51 in/hr. Geotechnical report prepared as part of the city permit requirement showed that the initial infiltration was 0.32 in/hr, the final was 0.15in/hr, and decay constant was 0.1 Shr-1. Some residents complained that there was water accumulated at their properties cause some damages. Residents threatened to take legal action against the developer. The developer hired your company to investigate what had happen. You are assigned to the project and been asked by your supervisor to perform the following calculations: 1. What is the interception?
2. What is the infiltration?
3. In your opinion and based on your analysis do you believe that the residents allegations are founded?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Apressure vessel with an r/t 20 cannot be treated as thin walled vessel. a)-trune b)- false

Answers: 3

Answer

You know the right answer?

A new development is being proposed over a 10 acres site. The developer wants to divide the site int...

Questions