Engineering, 20.05.2021 17:20 kenzielema12

A circular steel axle has a yield stress,σY= 50 ksi, and a diameter of 1.5 inches. If this axle issubjected to torsional loading, determine the allowable torque for a factor of safety FS = 1.7 using themaximum distortional energy (von Mises) failure theory.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options

Answers: 2

Answer

Engineering, 04.07.2019 19:20

A21-tooth spur pinion mates with a 28-tooth gear. the diametral pitch is 3 teeth/in and the pressure angle is 20°, find the following values: the addendum, dedendum, circular pitch, tooth thickness, and base circle diameters.

Answers: 2

Answer

Engineering, 06.07.2019 02:30

An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?

Answers: 3

Answer

You know the right answer?

A circular steel axle has a yield stress,σY= 50 ksi, and a diameter of 1.5 inches. If this axle issu...

Questions