subject
Engineering, 21.05.2021 01:00 tommyaberman

Interior designer Krista receives a job to completely renovate the interiors of a series of shop spaces in a building that has just changed ownership. Krista notices some troubling issues with the arrangement of the HVAC system, but she ignores those and concentrates on the interior design
because she is on a tight schedule and budget. She decides to focus mainly on cosmetic issues and doesn't bother with moving or taking down
walls or other deeper changes. A space that was fitted out as a salon stays a salon, and a space fitted out with dressing rooms and mirrors as a
retail clothing shop keeps its dressing rooms and mirrors. If the client has problems with Krista's work, what are the likely contributing factors?
(Select all that apply.)
Krista sees problems with the HVAC system and yet chooses to ignore these issues instead of informing the client and trying to fix them
Krista only appears to be concerned with keeping within her allotted schedule and budget and not going beyond that
Krista didn't bother to address the function of each shop space to make each one more versatile and useful for a variety of occupants
Krista basically just does what an interior decorator would do in this situation without addressing deeper design issues

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
question
Engineering, 04.07.2019 18:20
Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.
Answers: 2
You know the right answer?
Interior designer Krista receives a job to completely renovate the interiors of a series of shop spa...
Questions
Questions on the website: 13722359