Engineering, 24.05.2021 20:50 dinadenoirefan

Consider the effect of the catcher mechanism on the final (maximum) height. The catcher mechanism is not taken into account in our calculations. Based on this, do you think the calculated velocity of the pendulum plus ball immediately after colision, higher or lower than the true velocity of the pendulum plus ball immediately after collision? Is the calculated initial velocity of the ball, higher or lower than the true velocity of the ball? Based on this, do we expect the speed of the ball calculated from the photogate time to be larger or smaller than the speed obtained from the ballistic pendulum calculation? Does this agree with the experimental data? If the effect of the massless rod approximation is to lower the ballistic pendulum result by about 5% compared to the true value, estimate the effect of the catcher mechanism fassuming this is the other main source of error)

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

You know the right answer?

Consider the effect of the catcher mechanism on the final (maximum) height. The catcher mechanism is...

Questions