Engineering, 26.05.2021 16:20 covergurllaa

A mixture of pulverized fuel ash and Portland cement to be used for grouting should have a true average compressive strength of more than 1300 KN/m2. The mixture will not be used unless experimental evidence indicates conclusively that the strength specification has been met. State the relevant hypotheses, and describe the type I and type II errors in the context of this problem.

Answers: 1

Show answers

Answers

Null Hypothesis - True average compressive strength of mixture of pulverized fuel ash and Portland cement is more than 1300 KN/m2.

Type I error (false positive) - this occur when the True average compressive strength of mixture of pulverized fuel ash and Portland cement is not more than 1300 KN/m2 in actual scenario but the measurements shows an incorrect reading of True average compressive strength greater than 1300 KN/m2.

Type II error (false-negative)- his occur when the True average compressive strength of mixture of pulverized fuel ash and Portland cement is more than 1300 KN/m2 in actual scenario but the measurements show an incorrect reading of True average compressive strength less than 1300 KN/m2.

Explanation:

The hypothesis for this piece of information is as follows -

Null Hypothesis - True average compressive strength of mixture of pulverized fuel ash and Portland cement is more than 1300 KN/m2.

Alternate hypothesis - True average compressive strength of mixture of pulverized fuel ash and Portland cement is less than or equal to 1300 KN/m2

Answer from: Quest

At a roundabout you must yield to traffic already in the roundabout

Answer from: Quest

the warning light flashes for a second or two when the engine starts. if it stays on, there's must be something wrong with the coolant. you should never dare to continue driving when the light is on. pull over as soon as possible and shut the engine off.

hope this is what you're talking about

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

You know the right answer?

A mixture of pulverized fuel ash and Portland cement to be used for grouting should have a true aver...

Questions