subject
Engineering, 28.05.2021 19:40 csciahetano

On June 26, 1990, the high temperature recorded at PHX at approximately 4 pm was 122 oF and the barometric pressure was 29.65 inHg. Assume that the pressue reading is taken in a room where the pressure is equalized with the atmosphere, but the temperature is kept at 20 oC. The density of mercury at 40°C is 13,496.9 kg/m3, and the density decreases by approximately 2.44 kg/m3 per degree C. That is, for every degree above 40°C, the density will be reduced below 13,496.9 kg/m" by 2.44 kg/m. (a) What was the air density at PHX at 4 pm on June 20?
(b) The takeoff ground roll distance for an aircraft is approximately given as
dTo = 1.21/g W/s/pCLmax(T/W)
where W - aircraft weight, S - wing planform area, CLmax - maximum lift coefficient (a characteristic of the wing), and T - maximum engine thrust. The maxium available thrust for a turbofan engine is approximately directly proportional to air density. For an aircraft with a given takeoff weight, how much longer runway would be required on this hot day than would be required on a sea-level standard day (rho = 1.225 kg/m3).

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
question
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
question
Engineering, 04.07.2019 19:20
Liquid flows at steady state at a rate of 2 lb/'s through a pump, which operates to raise the elevation of the liquid 100 ft from control volume inlet to exit. the liquid specific enthalpy at the inlet is 40.09 btu/lb and at the exit is 40.94 btub. the pump requires 3 btu/s of power to operate. if kinetic energy effects are negligible and gravitational acceleration is 32.174 tt/s, the heat transfer rate associated with this steady state process is most closely 1)-2,02 btu/s from the liquid to the surroundings 2)-3.98 btu/s from the surroundings to the liquid. 3)-4.96 btu/s from the surroundings to the liquid. 4)-1.04 btu/s from the liquid to the surroundings.
Answers: 2
question
Engineering, 04.07.2019 19:20
List 3 options on how to reduce knocking problens during engine process,
Answers: 2
You know the right answer?
On June 26, 1990, the high temperature recorded at PHX at approximately 4 pm was 122 oF and the baro...
Questions
question
English, 08.10.2019 04:30
question
History, 08.10.2019 04:30
question
Mathematics, 08.10.2019 04:30
Questions on the website: 13722362