Engineering, 03.06.2021 16:20 veritoburito

Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa, 500C, and 80 m/s, and the exit conditions are 92 percent quality, and 50 m/s. The mass flow rate of the steam is 12 kg/s. Investigate the effect of the turbine exit pressure on the power output of the turbine. Let the exit pressure vary from 10 to 200 kPa (10 different pressure namely 10, 30, 40, 50, 75, 100, 125, 150, 175, 200 kpa is enough). Prepare a table and two plot as follows:
• Tabulate turbine exit pressure, the power output of the turbine and turbine exit temperature (the table template is below)
• Plot the power output against the exit pressure,
• Plot the exit temperature against the exit pressure,
• and discuss the results

Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa, 500

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

Answer

You know the right answer?

Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa, 500C...

Questions