Engineering, 04.06.2021 14:00 12345678822
Vincenzo Cassano, a well-known Italian Mafia aimed to torture
his enemy, Jang Han-Seok to death by using the drill bit
attached to a piston as shown in Figure Q2. The piston has a
diameter of 13 cm and length of 30 cm. The drill bit is 10 cm
length, and the system has to be located approximately 5 cm
from Han-Seok to ensure a maximum torture, allowing the bit
to penetrate 5 cm into Han-Seok’s chest.
At atmospheric pressure, 1⁄2 of the cylindrical piston is filled up
with water and being heated continuously in a way that there
will be expansion of the water in the piston and the drill bit will
move slowly, and torture Han-Seok. After several trials,
Vincenzo failed to ensure the drill bit works effectively as the
expansion is not sufficient enough to ensure the drill bit hits
Han-Seok’s chest (and now he laughs evilly because the plan
fails).As an engineer, Vincenzo hires you to ensure the
system works well. Using an appropriate P-v or T-v
diagrams, suggest some improvements that he could
make to ensure that he can still use the system with the
same length of drill bit and piston, yet it works well.
Provide necessary calculations (e. g. using the property
table) to proof the effectiveness of this new design,
compared to the initial design.
Answers: 3
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
Engineering, 04.07.2019 08:10
Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed
Answers: 1
Engineering, 04.07.2019 18:10
Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed.gi) ifn 1, what will happen to the material when transformed material when
Answers: 1
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Vincenzo Cassano, a well-known Italian Mafia aimed to torture
his enemy, Jang Han-Seok to death by...
Mathematics, 29.07.2021 20:00
Chemistry, 29.07.2021 20:00
Physics, 29.07.2021 20:00
Mathematics, 29.07.2021 20:00
Mathematics, 29.07.2021 20:00
Social Studies, 29.07.2021 20:00
Biology, 29.07.2021 20:00
Mathematics, 29.07.2021 20:10
Arts, 29.07.2021 20:10