subject
Engineering, 07.06.2021 16:20 ella3714

Time left 0:42:59 Two balanced three phase loads are connected in parallel, the loads are L,=30 kVA at 0.9 pf lag, and L2= 40 kW at 0.795 pf lag.
The loads are fed from a distribution line with an impedance of 0.1+j0.1 /0. The line to neutral voltage at the load end is 288 V
and zero phase shift, the phase current of the second load in A (if it is A-connected) is;
O A. 26.73-j20.39
O B. 33.35-14.30
O C. 100.04-112.89
O D. 80.19-361.18
O E 46.30-135.32
O F.57.76-17.44
O G. None
Two balanced three phase loads are connected in parallel, the loads are L1=30 KVA at 0.9 pf lag, and L2= 40 kW at 0.795 pf lag.
The loads are fed from a distribution line with an impedance of 0.1+j0.1 92/0. The line to neutral voltage at the load end is 288 V
and zero phase shift, the capacitance of A-connected capacitor bank that connected parallel to the loads to improve the power factor
to unity in uF is; (f=60 Hz)
A 154.92
OB. 51.64
OC 464.76
OD. 1394.28
O E. None​

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 18:10
What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information
Answers: 3
question
Engineering, 04.07.2019 18:20
Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]
Answers: 1
You know the right answer?
Time left 0:42:59 Two balanced three phase loads are connected in parallel, the loads are L,=30 kVA...
Questions
question
Mathematics, 08.09.2021 09:30
Questions on the website: 13722359