2.00 dia
Engineering, 09.06.2021 18:40 sanic123
11. For the hex cam, the distance across the
flats is measured to be 1.73 inches
2.00 dia
The square hole is .25 in square.
Calculate the maximum travel.
.25 in Sar
A. .270 in.
B. .135 in
C..125 in
D..5 in
Answers: 2
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?
Answers: 2
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
11. For the hex cam, the distance across the
flats is measured to be 1.73 inches
2.00 dia
2.00 dia
Mathematics, 03.02.2021 23:30
Mathematics, 03.02.2021 23:30
Chemistry, 03.02.2021 23:30
Mathematics, 03.02.2021 23:30
Mathematics, 03.02.2021 23:30
Mathematics, 03.02.2021 23:30
Mathematics, 03.02.2021 23:30
Mathematics, 03.02.2021 23:30
Mathematics, 03.02.2021 23:30
Mathematics, 03.02.2021 23:30
Business, 03.02.2021 23:30