Engineering, 10.06.2021 06:40 Jony4359

A SELF-CHECK 3.2
COMPONENT REPLACEMENT
TVL-11
Directions: Identify the term being described in each item.

1. It is one of the factors to consider in selecting replacement parts
that refers to the capability of local market to have the supply.

2. It is one of the factors to consider in selecting replacement parts
that refers to the conformity of the available parts as per
acceptable specification.

3. It is one of the factors to consider in selecting replacement parts
that refers to the ability to provide exact value/ specification.

4. It is one of the factors to consider in selecting replacement parts
that refers to the affordability of the replacement parts.

5. It contains the necessary data of a particular domestic appliance
including the schematic diagram.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)

Answers: 3

Answer

Engineering, 06.07.2019 03:20

What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.

Answers: 3

Answer

You know the right answer?

A SELF-CHECK 3.2
COMPONENT REPLACEMENT
TVL-11
Directions: Identify the term being de...

Questions