Engineering, 17.06.2021 22:50 nialphonsa

Oil spill cleanup costs for a nation or region can be estimated by taking the average cost for the specified region and multiplying it by various “modification factors” that are a function of oil type (light crude, heavy crude, No. 4 fuel, etc.), spill size (< 34 tons, 34–340 tons, etc.), location type (offshore, nearshore, in-port), cleanup method (dispersants, burning, manual), and extent of shoreline oiling (0–1 km, 2–5 km, etc.). For an average cost of $23.3 per liter and modifiers for a region in the United States of 1.35, 0.65, 1.28, 0.25, and 1.36 for oil type, spill size, location type, cleanup method, and extent of shoreline oiling, respectively, determine the estimated cleanup cost per liter of an oil spill in the region of the United States. The cleanup cost per liter of an oil spill in the region of the United States is estimated to be $
.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

You know the right answer?

Oil spill cleanup costs for a nation or region can be estimated by taking the average cost for the s...

Questions