There is a cantilever beam with a rectangular cross-section, loaded with uniformly distributed loading. As a result of this loading, considerable shear forces develop within the beam. The width of the beam is 120cm, while the height of the beam is 50cm. If you are required to design the beam against shear, would you use the shear formula? Explain the reason for your answer with 3 sentences, maximum.

The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux