subject
Engineering, 01.07.2021 15:40 amayarayne5

Consider a sphere ball that is made of a hypothetical metal. The diameter of the sphere ball is 0.5 m. The properties of the sphere ball k = 1 W/m-K, Q = 1 X 10-6 m2/s. The sphere ball is initially at a uniform temperature of 10 °C and is dropped into water at 90 °C. The convective heat transfer coefficient is h = 100 W/m2K. Determine the temperature at r = ro/4 from the center of the sphere ball 20 minutes after the sphere ball is dropped into the water using the one-term approximation method. Please elaborate your answer. Your answer must include Biot number, constants such as A1, explanation on your solving process, and the estimation for the temperature value. Grading rubric: accurate estimation of Biot number (15 points), accurate estimation of constants such as A1 (15 points), accurate use of equations and accurate estimate for the temperature (20 points). Note: You are not allowed upload any file. HTML Editor is disabled.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
question
Engineering, 04.07.2019 18:20
What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.
Answers: 3
question
Engineering, 04.07.2019 19:20
The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.
Answers: 3
question
Engineering, 04.07.2019 19:20
To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.
Answers: 1
You know the right answer?
Consider a sphere ball that is made of a hypothetical metal. The diameter of the sphere ball is 0.5...
Questions
question
SAT, 12.02.2020 21:55
question
Mathematics, 12.02.2020 22:03
Questions on the website: 13722363