Engineering, 06.07.2021 20:00 Marley3082

Consider the effect of the catcher mechanism on the final (maximum) height. The catcher mechanism is not taken into account in our calculations. Based on this, do you think the calculated velocity of the pendulum plus ball immediately after collision, higher or lower than the true velocity of the pendulum plus ball immediately after collision? Is the calculated initial velocity of the ball, higher or lower than the true velocity of the ball? Based on this, do we expect the speed of the ball calculated from the photogate time to be larger or smaller than the speed obtained from the ballistic pendulum calculation? Does this agree with the experimental data? If the effect of the massless rod approximation is to lower the ballistic pendulum result by about 5% compared to the true value, estimate the effect of the catcher mechanism fassuming this is the other main source of error)

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 12:10

On a average work day more than work place firs are reorted

Answers: 1

Answer

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives

Answers: 2

Answer

You know the right answer?

Consider the effect of the catcher mechanism on the final (maximum) height. The catcher mechanism is...

Questions