Engineering, 20.07.2021 05:10 naterjax

Determine the reactor volume (assume a CSTR activated sludge aerobic reactor at steady state) required to treat 5 MGD of domestic wastewater from an influent BOD concentration of 250 mg/L to an effluent concentration of 10 mg/L. X (MLVSS) = 3000 mg/L, and the kinetics are first order and not variable order. The first order equation you must use to calculate the specific substrate utilization rate is q = K S where S is the effluent BOD concentration and K is the first order BOD degradation rate constant. The value of K is 0.04 L/(day*mg). What is the required reactor volume in MG (millions of gallons)? All the choices below are in units of MG. 0.4
1.0
0.2
4.8

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Heat transfer by is the fastest mode of heat transfer that requires no intervening medium. a)-conduction b)-convection c)-radiation d)-conduction and convection

Answers: 1

Answer

Engineering, 06.07.2019 02:30

A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.

Answers: 1

Answer

Engineering, 06.07.2019 04:10

Agas mixture with a compostion of 55 methane, 30% propane, and 15 butane by volume) is compressed from 1 bar and 25°c to 9bar in a compressor with an isentropic efficiency of 85%. the environment has a temperature of to25 c. determine (a) the exit temperature of the mixture (b) the specific work required to run the compressor (c) the specific entropy generation of the process (d) the specific exergy destruction of the process (e) the second law efficiency of the compressor

Answers: 3

Answer

You know the right answer?

Determine the reactor volume (assume a CSTR activated sludge aerobic reactor at steady state) requir...

Questions