Engineering, 23.07.2021 03:50 montanolumpuy
The impeller shaft of a fluid agitator transmits 20 kW at 430 rpm. If the allowable shear stress in the impeller shaft must be limited to 65 MPa, determine (a) the minimum diameter required for a solid impeller shaft. (b) the maximum inside diameter permitted for a hollow impeller shaft if the outside diameter is 36 mm. (c) the percent savings in weight realized if the hollow shaft is used instead of the solid shaft. (Hint: The weight of a shaft is proportional to its cross-sectional area.)
Answers: 2
![$d=\sqrt[3]{\frac{16 T}{\pi \tau}}](/tpl/images/1398/4366/5f364.png)
![$d=\sqrt[3]{\frac{16 \times 444.37}{3.14 \times 65}}](/tpl/images/1398/4366/aa582.png)
![$d=\sqrt[3]{34.83} $](/tpl/images/1398/4366/50b34.png)
mm
Another question on Engineering
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:10
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
Engineering, 04.07.2019 18:10
Burgers vector is generally parallel to the dislocation line. a)-true b)-false
Answers: 2
You know the right answer?
The impeller shaft of a fluid agitator transmits 20 kW at 430 rpm. If the allowable shear stress in...
Questions
Mathematics, 11.06.2021 03:40
Mathematics, 11.06.2021 03:50
History, 11.06.2021 03:50
Mathematics, 11.06.2021 03:50
Social Studies, 11.06.2021 03:50
Mathematics, 11.06.2021 03:50
English, 11.06.2021 03:50
