Engineering, 03.08.2021 18:40 ms0579930

The first 25 mm section of a pin shaped fin with a diameter of 5 mm, a length of 50 mm and a heat conduction coefficient of 100 W/m-K is insulated. The remaining 25 mm part is in contact with air whose temperature is 20 °C and the heat transfer coefficient is 500 W/m2-K. The wall temperature to which the end of the insulated part of the fin is connected is given as 100 °C. The other end, whose temperature is 100 oC, has a thermal resistance of 4x10-4 m2-K/W at the interface. Calculate the temperature at the midpoint of this fin.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

You know the right answer?

The first 25 mm section of a pin shaped fin with a diameter of 5 mm, a length of 50 mm and a heat co...

Questions