(b)
The specification for the length of one component is 25 +0.2 mm.
Twenty consecutively man...
Engineering, 16.08.2021 01:00 princessroyal
(b)
The specification for the length of one component is 25 +0.2 mm.
Twenty consecutively manufactured components were sampled, and
the mean and standard deviation are 25.12 mm and 0.038 mm,
respectively.
Calculate the appropriate capability indices. Do you consider it safe to
proceed with the production run? Justify your decision.
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
You know the right answer?
Questions
Mathematics, 20.04.2021 00:44
Physics, 20.04.2021 00:44
English, 20.04.2021 00:44
Mathematics, 20.04.2021 00:44
Mathematics, 20.04.2021 00:44
Mathematics, 20.04.2021 00:44
Mathematics, 20.04.2021 00:44
Mathematics, 20.04.2021 00:44
Mathematics, 20.04.2021 00:44
History, 20.04.2021 00:44
Mathematics, 20.04.2021 00:44
