Engineering, 17.08.2021 01:10 sadmomsclub

Choose all of the two-phase material systems from the list below. (a) Solid ductile cast iron (ferrite solid solution + embedded graphite spheres)
(b) Solid sodium chloride (salt, NaCl)
(c) Liquid bronze (Cu + Sn liquid solution)
(d) Solid gray cast iron (ferrite solid solution + embedded graphite flakes)
(e) Solid aluminum featuring dissolved silicon
(f) Solid lead-tin solder (a mixture of Pb-rich and Sn-rich solid solutions)
(g) Partially melted aluminum
(h) Frozen water with trapped air bubbles
(i) Epoxy embedded with carbon fibers

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

Choose all of the two-phase material systems from the list below. (a) Solid ductile cast iron (ferr...

Questions

Engineering, 23.04.2021 22:00

A piece of corroded steel plate was found in a submerged ocean vessel. It was estimated that the original area of the plate was 5 in.2 and that approx...