Engineering, 23.08.2021 16:10 officialrogerfp3gf2s
From the list below, select three metallurgical/processing techniques that are employed to enhance the creep resistance of metal alloys. Dispersion strengthening by using an insoluble second phase. Unidirectional solidification of alloys. Hardening (carburizing, nitriding) or shot peening. Polishing the surface to remove stress amplification sites. Anneal the metal alloy. Increasing the grain size or producing a grain structure with a preferred orientation. Solid solution alloying. eTextbook and Media
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
Engineering, 04.07.2019 18:10
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
You know the right answer?
From the list below, select three metallurgical/processing techniques that are employed to enhance t...
Questions
Computers and Technology, 07.10.2019 18:30
