Engineering, 07.09.2021 04:50 kell22wolf

1.a) The electricity consumed in kwh/unit of 50 household of a certain community were as follows.68, 84, 73, 82, 68, 90, 62, 88, 76, 93, 73, 79, 75, 60, 93, 71, 59, 85, 75, 61, 65, 88, 87, 74, 62, 95, 78, 63, 72, 66, 78, 75, 75, 94, 77, 69, 74, 68, 60, 96, 78, 82, 51, 52, 53, 61, 75, 95, 98 and 60.From the above information i) construct the grouped frequency distribution having suitable class and class interval ii) draw a less than ogive and find the percentage of families who consumed 60 unit or below iii) find third quartile graphically.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

1.a) The electricity consumed in kwh/unit of 50 household of a certain community were as follows.68,...

Questions