Engineering, 23.09.2021 03:10 jasonskatesallday

You are given an Expert System with the following rules: R1: IF interest rates fall, THEN bond prices will increase.
R2: IF interest rates increase, THEN bond prices will decline.
R3: IF interest rates are unchanged, THEN bond prices will remain unchanged.
R4: IF the dollar rises (against other currencies), THEN interest rates will decline.
R5: IF the dollar falls, THEN interest rates will increase.
R6: IF bond prices decline, THEN buy bonds.
a. A client has just observed that the dollar exchange rate is falling. He wants to know whether to buy bonds. Run forward chaining and backward chaining, and submit a report of your findings to him.
b. Prepare an inference tree for the backward chaining you did.
c. A second client has observed that interest rates are unchanged. She asks for advice on investing in bonds. What will the ES tell her? Use forward chaining to figure it out.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:10

Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

Answer

Engineering, 06.07.2019 02:30

Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers

Answers: 3

Answer

You know the right answer?

You are given an Expert System with the following rules: R1: IF interest rates fall, THEN bond pri...

Questions