Engineering, 19.10.2021 01:00 mauifrifer3986

For the slab system of Storage warehouse with heavy equipment that shown in the plan below, use ACL code Load combinations table and following available data.
Find out the
1. Ultimate area load ( w ) kN/m2 on slab 1
2. Ultimate Linear load ( Wu) kN/m on Beaml and Beam 2
3- Ultimate Point load (Pe) kN on Col. l. Col.2 and Col. 3
Available data for Dead Load calculation
Slab thickness = 0.21m
Assume Reinforced concrete density = 23.8 kN/m
*
Superimposed dead load = 1.2 kN/
m2
Use Table 1.1 for assuming Live load on the slab with respect to its occupation
800 m
600 m
Coll
Beam 1
Slable
1 00 m
Col
Col
900 m
Beam
(1.21 m
1.6 mm
110 m

For the slab system of Storage warehouse with heavy equipment that shown in the plan

below, use A

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 19:10

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

A)-explain briefly the importance of standards in engineering design. b)- what is patent? c)-explain the relationship between these standards: b.s. and b.s.en d)- in engineering design concepts, types of loads and how they act are important factors. explain.

Answers: 3

Answer

Engineering, 04.07.2019 19:20

The process in which the system pressure remain constant is called a)-isobaric b)-isochoric c)-isolated d)-isothermal

Answers: 3

Answer

You know the right answer?

For the slab system of Storage warehouse with heavy equipment that shown in the plan below, use AC...

Questions