subject
Engineering, 23.10.2021 03:30 letsgivepece2309

While keeping the presentation that you just listened in mind, it is expected of you to prepare a gamification project idea draft that could solve one of the issues that are given below. Each one of you should only choose one topic.1 – (Client: IETT, Target: Working and studying people who live in İstanbul and have to deal with the perils of public transportation daily)We have a huge traffic problem at İstanbul! A small but deadly part of this situation is how crowded it gets if one wants to use mass transportation. Regarding this, you are expected to find a solution using gamification to the problem of getting in and out from those public transportation vehicles. You should choose one means of public transportation (such as the bus or metrobus) and create your idea around it. Don’t forget! The problem is about just how we get on the vehicle and get off from it!

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 18:20
Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t
Answers: 3
You know the right answer?
While keeping the presentation that you just listened in mind, it is expected of you to prepare a ga...
Questions
question
Mathematics, 02.09.2019 09:30
Questions on the website: 13722361