Engineering, 25.10.2021 07:50 kamkam6200

Q3 : Assume the Following Process. Process Burst Time Priority Arrival Time
P1 18 3 0
P2 4 1 1
P3 2 5 2
P4 6 4 3
P5 10 2 30
For the set of processes directly above, draw a Gantt chart for the SJF (Shortest Job
First – Non-Preemptive) Scheduling Algorithm. With CS = 0.
a) For the set of processes directly above, calculate the throughput for the SJF
(Shortest Job First -Non-Preemptive) Scheduling Algorithm.
b) For the set of processes directly above, calculate the turnaround time for
the SJF (Shortest Job First- Non-Preemptive) Scheduling Algorithm.
c) For the set of processes directly above, calculate the average turnaround
time for the SJF (Shortest Job First Non-Preemptive) Scheduling Algorithm.
d) For the set of processes directly above, calculate the waiting time for the
SJF (Shortest Job First Non-Preemptive) Scheduling Algorithm.
e) For the set of processes directly above, calculate the average waiting
time for the SJF (Shortest Job First) Scheduling Algorithm.
f) What is the CPU Utilization for the system?
Q 4 : Repeat Q2 with CS=1

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

You know the right answer?

Q3 : Assume the Following Process. Process Burst Time Priority Arrival Time
P1 18 3 0
...

Questions