A concrete dam is 32m long from the upstream side to the downstream end. The dam is situated on an 18 m thick stratum of soil that has a coefficient of permeability equal to 0.5 m per day. Firm, hard clay and rock lie underlie the described soil stratum. The base of the dam is installed at a level 2 m below the natural soil surface. Required:
Draw the flownet for seepage occurring beneath the dam, and compute seepage in cubic meter per day per meter of dam width (perpendicular to the paper) for the conditions where the reservoir water against the upstream face of the dam is 20m above the soil surface and water level at the downstream end is at 2m above the soil surface.

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid