Engineering, 26.10.2021 22:20 quintinlarrieu
A francis turbine is used in an installation to generate power. The power output is 115000 hp under a head of 480ft. The outer radius of the rotor is 6.75ft; the inner radius is 5.75ft. The rotational speed is 180 RPM, and the blade height is 1.5ft. The turbine efficiency is 0.95 percent. The absolute velocity leaving the rotor is in the radical direction.
Required:
Determine the angle that the absolute velocity entering the rotor makes with radial direction.
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
You know the right answer?
A francis turbine is used in an installation to generate power. The power output is 115000 hp under...
Questions
Mathematics, 10.06.2020 04:57
Mathematics, 10.06.2020 04:57
Mathematics, 10.06.2020 04:57
History, 10.06.2020 04:57
History, 10.06.2020 04:57
