subject
Engineering, 30.10.2021 07:50 sineguguhopengw3912

10 points) If a filter has unity gain (i. e. 0 dB) in its passband, you know that the frequency at which the output has half the amplitude of the input is known as the cutoff frequency. Hence, the gain is -3 dB at the cutoff frequency. However, if the maximum gain in the passband is not 0 dB, the cutoff frequency is the point where the gain is 3 dB lower than the maximum gain. When measuring cutoff frequency from a Bode plot, if you notice that the maximum gain is 8 dB, then what is the gain at the cutoff frequency?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
question
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
question
Engineering, 04.07.2019 18:20
Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.
Answers: 2
You know the right answer?
10 points) If a filter has unity gain (i. e. 0 dB) in its passband, you know that the frequency at w...
Questions
Questions on the website: 13722361