subject
Engineering, 06.11.2021 02:40 kelseeygee

* 4. Annika’s class is investigating energy. They wonder what would happen to the temperature reading on a thermometer if they put the thermometer inside a mitten (see diagram A above). Both thermometers started at room temperature. Annika’s group obtained two thermometers and a mitten. They put one thermometer inside the mitten and the other thermometer on the table next to the mitten. An hour later they compared the readings on the two thermometers. The temperature inside the room remained the same during their experiment. The thermometer inside the mitten will have a lower temperature reading than the thermometer on the table because the mitten will conduct the cold air outside the thermometer. Both thermometers will have the same temperature reading because the mitten doesn’t generate additional heat. The thermometer inside the mitten will have a higher temperature reading than the thermometer on the table because the mitten will trap the warm air inside the mitten. The thermometer inside the mitten will have a higher temperature reading than the thermometer on the table because the mitten will insulate the thermometer.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
question
Engineering, 04.07.2019 18:20
Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.
Answers: 3
question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
question
Engineering, 06.07.2019 03:10
Two slings are used to lift a girder of length l and uniform weight per unit length. what is the best position for the slings if the bending moment due to the weight of the girder is to be kept to a minimum?
Answers: 2
You know the right answer?
* 4. Annika’s class is investigating energy. They wonder what would happen to the temperature readin...
Questions
question
Mathematics, 09.04.2021 15:30
question
Mathematics, 09.04.2021 15:30
question
History, 09.04.2021 15:30
question
Mathematics, 09.04.2021 15:30
question
Mathematics, 09.04.2021 15:30
question
Mathematics, 09.04.2021 15:30
question
Mathematics, 09.04.2021 15:30
Questions on the website: 13722363