Engineering, 22.11.2021 23:20 jalenshayewilliams
17. A(n) joint is made by placing the edges of the plates together evenly, with no gap between the plates
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 04.07.2019 18:10
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
You know the right answer?
17. A(n) joint is made by placing the edges of the plates together evenly, with no gap between the p...
Questions
Mathematics, 16.02.2021 21:20
Mathematics, 16.02.2021 21:20
Social Studies, 16.02.2021 21:20
English, 16.02.2021 21:20
Chemistry, 16.02.2021 21:20
Mathematics, 16.02.2021 21:20
Mathematics, 16.02.2021 21:20
Chemistry, 16.02.2021 21:20
Physics, 16.02.2021 21:20
