Engineering, 25.11.2021 07:00 shadenShaden2037
Compare precipitation hardening (Sections 11.10 and 11.11) and the hardening of steel by quenching and tempering (Sections 11.5, 11.6, and 11.8) with regard to the following: (a) The total heat treatment procedure (b) The microstructures that develop (c) How the mechanical properties change during the several heat treatment stages
Answers: 1
Engineering, 04.07.2019 18:10
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
Engineering, 04.07.2019 18:20
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
Engineering, 04.07.2019 19:10
What are the major differences between injection molding and extrusion?
Answers: 2
Engineering, 06.07.2019 02:30
An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?
Answers: 3
Compare precipitation hardening (Sections 11.10 and 11.11) and the hardening of steel by quenching a...
Mathematics, 28.03.2020 03:44
Mathematics, 28.03.2020 03:44
Mathematics, 28.03.2020 03:44
Mathematics, 28.03.2020 03:44
Mathematics, 28.03.2020 03:44
Mathematics, 28.03.2020 03:44
Mathematics, 28.03.2020 03:44
Mathematics, 28.03.2020 03:45
Mathematics, 28.03.2020 03:45
History, 28.03.2020 03:45