subject
Engineering, 25.11.2021 14:00 whitethunder05

A refrigeration cycle driven by an electric motor must maintain a computer laboratory at 188C when the outside temperature is 308C The thermal load consists of heat transfers entering through the walls and roof of the laboratory at a rate of 75,000 kJ/h and from the computers, lighting, and occupants at a rate of 15,000 kJ/h. Required:
a. Determine the minimum theoretical power required by the electric motor, in kW, and the corresponding coefficient of performance.
b. If the actual power required by the motor for this duty is 8.3 kW, determine the coefficient of performance.
c. If the given temperature and thermal load data are observed for a total of 100 hours and electricity costs 13 cents per kWh, determine the cost, in $, over that period for each of cases (a) and (b).

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 18:10
Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs
Answers: 2
question
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
question
Engineering, 06.07.2019 02:30
Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers
Answers: 3
You know the right answer?
A refrigeration cycle driven by an electric motor must maintain a computer laboratory at 188C when t...
Questions
question
Mathematics, 19.11.2020 04:40
question
Chemistry, 19.11.2020 04:40
question
Mathematics, 19.11.2020 04:40
question
Health, 19.11.2020 04:40
question
Spanish, 19.11.2020 04:40
Questions on the website: 13722362