Engineering, 01.12.2021 02:40 ineedtopeebeforethec

A student made a table comparing erosion caused by glaciers and hurricanes. Is the table correct? Glaciers Hurricanes
The movement of glaciers causes rocks to move

Occurs slowly The strong winds and waves common to hurricanes causes sand to move

Occurs quickly
Yes, because both forms of erosion involve the movement of rocks and soil.
No, because erosion always occurs quickly.
Yes, because erosion is a process that only involves water.
No, because only hurricanes use their movement to cause rocks and soil to move.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.

Answers: 3

Answer

You know the right answer?

A student made a table comparing erosion caused by glaciers and hurricanes. Is the table correct?...

Questions