subject
Engineering, 04.12.2021 01:10 abrown8483

A ceramic is tested in 3-point bend. The ceramic has a flexural strength of 300 MPa. What is the failure load (in Newtons) if the specimen width is 8 mm, specimen height is 2.5 mm and the length is 20 mm between the two lower supports

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 18:20
Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?
Answers: 1
You know the right answer?
A ceramic is tested in 3-point bend. The ceramic has a flexural strength of 300 MPa. What is the fai...
Questions
question
English, 26.01.2021 01:00
question
History, 26.01.2021 01:00
question
Mathematics, 26.01.2021 01:00
question
Computers and Technology, 26.01.2021 01:00
question
Mathematics, 26.01.2021 01:00
question
English, 26.01.2021 01:00
question
Mathematics, 26.01.2021 01:00
Questions on the website: 13722363