Engineering, 07.12.2021 06:00 LiliGrey7612
A Rankine cycle operates between pressures of 2 MPa and 10 kPa with a maximum temperature of 600 o C. The pump can be assumed reversible and adiabatic and its inlet is saturated water. Assuming adiabatic turbine with an isentropic efficiency of 80 percent, and neglecting changes in kinetic and potential energies:
i. Determine the specific turbine work.
ii. Determine the thermal efficiency of the cycle
iii. Determine the temperature of the steam at the turbine outlet.
iv. Determine the temperature of the water at the pump outlet.
Answers: 2
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Engineering, 04.07.2019 18:20
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50Β°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 Β°c. sutherland constant for air is 111k
Answers: 3
Engineering, 06.07.2019 03:10
Steel balls 12 mm in diameter are annealed by heating to 1150 k and then slowly cooled to 400 k in an air att 325 k and h -20 w/m2 k. assume the properties of the steel to be k- 40 w/m k,p 7800 kg/m3, and cp 600 j/kg k. a. determine whether lumped system method can be used to analyze this problem and if so why" b. determine the time required for the cooling process. c. determine the total amount of heat lost from each ball to the ambient air
Answers: 1
A Rankine cycle operates between pressures of 2 MPa and 10 kPa with a maximum temperature of 600 o C...
History, 22.03.2021 22:10
Mathematics, 22.03.2021 22:10
Biology, 22.03.2021 22:10
Chemistry, 22.03.2021 22:10
Mathematics, 22.03.2021 22:10
Mathematics, 22.03.2021 22:10
SAT, 22.03.2021 22:10
Geography, 22.03.2021 22:10
Mathematics, 22.03.2021 22:10