Engineering, 07.12.2021 19:30 maybrieldridge12
In the engineering design and prototyping process, what is the advantage of drawings and symbols over written descriptions?
Answers: 1
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
Engineering, 04.07.2019 18:10
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
In the engineering design and prototyping process, what is the advantage of drawings and symbols ove...
Mathematics, 24.02.2021 18:10
Mathematics, 24.02.2021 18:10
Physics, 24.02.2021 18:10
Chemistry, 24.02.2021 18:10
Mathematics, 24.02.2021 18:10
Mathematics, 24.02.2021 18:10
English, 24.02.2021 18:10
Mathematics, 24.02.2021 18:10
Mathematics, 24.02.2021 18:10
Mathematics, 24.02.2021 18:10