Engineering, 10.12.2021 18:30 Riley3833

25. Ratchets and Screwdrivers are the same tool. True or False
26. A battery tester can be used to jump start a vehicle.
True or False
27. An adjustable wrench is good to have as it can be changed to fit any nut size. True or False
28. A Mechanic stethoscope is specially designed so that the noises produced by a problem in the vehicle can be identified.
True or False
29. A Compression Tester test the performance of the engine valves and piston rings. True or False
30. A battery pack is a good tool to have when travelling.
True or False
31. Using the correct size hand tool makes it easier to tighten or loosen nuts, bolts and screws.
True or False
32. A computer scanner can tell you every problem in a vehicle.
True or False
33. A Breaker Bar gives the same torque as regular length wrenches. True or False
34. A Pilot Bearing Puller can also be used to pull out a Crankshaft. True or False
25. Ratchets and Screwdrivers are the same tool.
True or False
26. A battery tester can be used to jump start a vehicle.
True or False
27. An adjustable wrench is good to have as it can be changed to fit any nut size. True or False
28. A Mechanic stethoscope is specially designed so that the noises produced by a problem in the vehicle can be identified.
True or False
29. A Compression Tester test the performance of the engine valves and piston rings. True or False
30. A battery pack is a good tool to have when travelling.
True or False
31. Using the correct size hand tool makes it easier to tighten or loosen nuts, bolts and screws.
True or False
32. A computer scanner can tell you every problem in a vehicle.
True or False
33. A Breaker Bar gives the same torque as regular length wrenches. True or False
34. A Pilot Bearing Puller can also be used to pull out a Crankshaft. True or False

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

25. Ratchets and Screwdrivers are the same tool. True or False
26. A battery tester can be...

Questions