subject
Engineering, 10.12.2021 19:20 Kassi07

If you are representing the owner/engineer, and during the bidding phase of a project, a bidder telephones your office calling attention to what the bidder believes to be an error, and makes a request for clarification or correction, you should: . A. check out the reported error while still on the telephone, give the caller the corrected data orally, then send an addenda to everyone e1se .
B. deny that an error exists and tell the caller to bid the work as it was specified and make his or her own interpretations.
C. take all of the information from the caller, then advise him or her to bid the job as it was originally specified unless an addenda is issued, and that if an error was in fact discovered, it will be corrected by addenda which will be mailed to all bidders.
D. try to be as helpful as possible by checking with the original designer; then, if an error is noted, give the caller the correct information, but do not go out of your way to inform others unless they call with the same question.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa
Answers: 1
question
Engineering, 04.07.2019 18:20
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
question
Engineering, 04.07.2019 19:10
An electric kettle is made out of stainless steel, weighs two pounds (when empty) and is equipped with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling
Answers: 2
You know the right answer?
If you are representing the owner/engineer, and during the bidding phase of a project, a bidder tele...
Questions
question
Mathematics, 30.01.2020 21:48
question
Computers and Technology, 30.01.2020 21:48
Questions on the website: 13722367