Engineering, 13.12.2021 14:00 shirleyyxo

Consider a water-cooled compressor operating at steady state. In the compressor, R134-a is compresseConsider a water-cooled compressor operating at steady state. In the compressor, R134-a is compressed from state 1 (saturated vapor, 1 bar) to state 2 (8 bar). The mass flow rate of the R134a is 0.9 kg/min while the HT from the compressor
by water cooling is 140 kJ/min. If the power input to the ccompressor is 3 kW, calculate the R134a exit temperature from
the compressord from state 1
(saturated vapor, 1 bar) to state 2 (8 bar). The mass flow rate of the R134a is 0.9 kg/min while the HT from the compressor
by water cooling is 140 kJ/min. If the power input to the ccompressor is 3 kW, calculate the R134a exit temperature from
the compressor

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

An electric kettle is made out of stainless steel, weighs two pounds (when empty) and is equipped with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Acircular aluminum shaft mounted in a journal is shown. the symmetric clearance gap between the shaft and journal is filled with sae 10w-30 oil at t 30°c. the shaft is caused to turn by the attached mass and cord. develop and solve a differential equation for the angular speed of the shaft as a function of time.

Answers: 2

Answer

You know the right answer?

Consider a water-cooled compressor operating at steady state. In the compressor, R134-a is compresse...

Questions