Engineering, 14.12.2021 01:00 kitykay2776

An estimate of the uncertainty for the concentration of an unknown sample can be determined based on the uncertainty in the calibration data set and the unknown sample analysis. The uncertainty (Sx) value is unitless when using the internal standard method of calibration. The uncertainty needs to be expressed in terms of the concentration units used for the standards (i. e. ppm). Calculated the uncertainty value in terms of concentration (Sc) for the diluted AND undiluted sample based on the following information. Uncertainty (Sx; unitless) based on the calibration data set and the unknown sample. Sx = 0.0152

Sample preparation: A whiskey sample is prepared for analysis by GC-FID using the internal standard method of calibration. A 20 mL sample is transferred using a volumetric pipet to a 50 mL volumetric flask. A volume of stock solution of the internal standard is added to the sample flask. The flask is diluted to volume.

Concentration of the internal standard in the diluted unknown = 500 ppm.

A. Sc(dilute) = 8 ppm, Sc(undilute) = 20 ppm
B. Sc(dilute) = 7 ppm, Sc(undilute) = 19 ppm
C. Sc(dilute) = 7.75 ppm, Sc(undilute) = 19.31 ppm
D. Sc(dilute) = 8 ppm, Sc(undilute) = 30 ppm

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

An electric kettle is made out of stainless steel, weighs two pounds (when empty) and is equipped with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

A5 kg block of fe is dropped into a very large vat of water. the fe and water initial temperatures are 95 and 25 c, respectively. the fe final temperature is 25 c and the water can be treated as a thermal reservoir,. treated as a thermal reservoir take the water to be the system and determine the entropy generation. report vour answer in kj/k.

Answers: 1

Answer

You know the right answer?

An estimate of the uncertainty for the concentration of an unknown sample can be determined based on...

Questions