Engineering, 15.12.2021 14:00 husamramadan83

Theres a group of terorist on the bank robing it othere one put a plant a time bomb 9minutes left of the time and the terorist
got arrested by a group of swat team after they got arrest
the time left is 1minutes there is one swat saw it he open the bomb
and theres 4 wires the( red)one go to the battery
the (blue) one go make the time stop and blow up
the( green) one make the bomb more faster the time moves
the( yellow one make the time low to move
_
A(green) cut
B(red) cut
C(yellow) cut
D(yellow) cut
_
good luck on the bomb thats just a easy quastion
im givving points whos the one who can cut the wire
and if the correct wire ill give you brainlies

Theres a group of terorist on the bank robing it othere one put a

plant a time bomb 9minutes left

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 19:30

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Apreheater involves the use of condensing steam at 100°c on the inside of a bank of tubes to heat air that enters at 1 atm and 25°c. the air moves at 5 m/s in cross flow over the tubes. each tube is 1 m long and has an outside diameter of 10 mm. what is the minimum value of nl needed to achieve an outlet temperature of t 75 c? what is the corresponding pressure drop across the tube bank?

Answers: 3

Answer

You know the right answer?

Theres a group of terorist on the bank robing it othere one put a plant a time bomb 9minutes left...

Questions